Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
227
config access_profile profile_id (ipv6)
• priority <value 0-7> − This parameter is specified to re-write
the 802.1p default priority previously set in the Switch, which is
used to determine the CoS queue to which packets are
forwarded to. Once this field is specified, packets accepted by
the Switch that match this priority are forwarded to the CoS
queue specified previously by the user.
• {replace_priority} − Enter this parameter to re-write the 802.1p
default priority of a packet to the value entered in the Priority
field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority
re-written to its original value before being forwarded by the
Switch.
deny – Specifies that packets that match the access profile are not
permitted to be forwarded by the Switch and will be filtered.
mirror - Selecting mirror specifies that packets that match the access
profile are mirrored to a port defined in the config mirror port
command. Port Mirroring must be enabled and a target port must be
set. Remember, Port Mirroring cannot cross-box, that is they cannot
span across switches in a switch stack.
delete access_id <value 1-65535> − Use this command to delete a
specific rule from the IPv6 profile. Up to 65535 rules may be
specified for the IPv6 access profile.
Restrictions Only administrator-level users can issue this command.
NOTE: When using the ACL Mirror function, ensure that the Port Mirroring
function is enabled and a target mirror port is set.
Example usage:
To configure a previously created access profile based on IPv6 classification:
DGS-3324SRi:4#config access_profile profile_id 4 add access_id 1
ipv6 class 1 flowlabel 0xABCD port 1:4 deny
Command: config access_profile profile_id 4 add access_id 1 ipv6
class 1 flowlabel 0xABCD port 1:4 deny
Success.
DGS-3324SRi:4#
delete access_profile
Purpose Used to delete a previously created access profile.
Syntax
delete access_profile profile_id <value 1-8>
Description
The delete access_profile command is used to delete a
previously created access profile on the Switch.