Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
294
config dvmrp
neighbor_timeout <second 1-65535> − The time period for
which DVMRP will hold Neighbor Router reports before issuing
poison route messages. The default value is 35 seconds.
state [enable | disable] − Allows DVMRP to be enabled or
disabled.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure DVMRP configurations of IP interface System:
DGS-3324SRi:4#config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Command: config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Success
DGS-3324SRi:4#
enable dvmrp
Purpose Used to enable DVMRP.
Syntax
enable dvmrp
Description
This command, in combination with the disable dvmrp
command below, to enable and disable DVMRP on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To enable DVMRP:
DGS-3324SRi:4#enable dvmrp
Command: enable dvmrp
Success.
DGS-3324SRi:4#
disable dvmrp
Purpose Used to disable DVMRP.
Syntax
disable dvmrp
Description
This command, in combination with the enable dvmrp
command above, to enable and disable DVMRP on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To disable DVMRP: