Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
333
show ospf virtual_neighbor
Purpose Used to display the current OSPF virtual neighbor router table.
Syntax
show ospf virtual_neighbor {<area_id> <neighbor id>}
Description This command will display the current OSPF virtual neighbor
router table.
Parameters
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for the neighbor. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area’s Area Border Router.
Restrictions None.
Usage Example
To display the current OSPF virtual neighbor table:
DGS-3324SRi:4#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit Router ID of IP Address of Virtual Neighbor
Area ID Virtual Neighbor Virtual Neighbor State
------------ ---------------- --------------- ----------------
10.1.1.1 10.2.3.4 10.48.74.111 Exchange
Total Entries : 1
DGS-3324SRi:4#
config ospf ipif
Purpose Used to configure the OSPF interface settings.
Syntax
config ospf ipif <ipif_name 12> {area <area_id> | priority
<value> | hello_interval <sec 1-65535>| dead_interval <sec 1-
65535> | authentication [none | simple <password 8> | md5
<key_id 1-255>] | metric <value 1-65535> | state [enable |
disable]}
Description This command is used to configure the OSPF interface settings.