Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
256
29
TIME AND SNTP COMMANDS
The Simple Network Time Protocol (SNTP) {an adaptation of the Network Time Protocol (NTP)} commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time <date ddmthyyyy> <time hh:mm:ss>
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day
sun-sat>| s_mth <start_mth 1-12> | s_time <start_time hh:mm> |
e_week <end_week 1-4,last> | e-day <end_day sun-sat> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]}]
show time
Each command is listed, in detail, in the following sections.
enable sntp
Purpose Enables SNTP server support.
Syntax
enable sntp
Description This will enable SNTP support. SNTP service must be separately
configured (see config sntp). Enabling and configuring SNTP
support will override any manually configured system time
settings.
Parameters None.
Restrictions Only administrator-level users can issue this command. SNTP
settings must be configured for SNTP to function (config sntp).
Example usage:
To enable the SNTP function:
DGS-3324SRi:4#enable sntp
Command: enable sntp
Success.
DGS-3324SRi:4#