Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
60
show error ports
Parameters
<portlist> − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical
order.
Restrictions None.
Example usage:
To display the errors of the port 3 of module 1:
DGS-3324SRi:4#show errors ports 1:3
Command: show errors ports 1:3
RX Frames TX Frames
--------------- ----------------
CRC Error 19 Excessive Deferral 0
Undersize 0 CRC Error 0
Oversize 0 Late Collision 0
Fragment 0 Excessive Collision 0
Jabber 11 Single Collision 0
Drop Pkts 20837 Collision 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show utilization
Purpose Used to display real-time port and CPU utilization statistics.
Syntax
show utilization [ports | cpu]
Description This command will display the real-time port and CPU utilization
statistics for the Switch.
Parameters cpu – Entering this parameter will display the current CPU
utilization of the Switch, as a percentage.
ports - Entering this parameter will display the current utilization
of all ports on the Switch.
Restrictions None.
Example usage:
To display the port utilization statistics: