Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
276
Route Source Metric Metric Type
RIP 0 to 16777214 mettype 1
mettype 2
Static 0 to 16777214 mettype 1
mettype 2
Local 0 to 16777214 mettype 1
mettype 2
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To add route redistribution settings:
DGS-3324SRi:4#create route redistribute dst ospf src rip
Command: create route redistribute dst ospf src rip
Success.
DGS-3324SRi:4#
create route redistribute dst rip src
Purpose Used to add route redistribution settings for the exchange of OSPF
routes to RIP routes on the Switch.
Syntax
create route redistribute dst rip src {all | internal | external |
type_1 | type_2 | inter+e1 | inter+e2}] {metric <value>}
Description This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local switch is also redistributed
Parameters
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
• all – Specifies both internal an external.
• internal – Specifies the internal protocol of the source device.
• external - Specifies the external protocol of the source device.
• type_1 - Calculates the metric (for RIP to OSPF) by adding the
destination’s interface cost to the metric entered in the Metric
field.
• type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
• inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
• inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a HOP Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.