Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
268
create vrrp vrid
critical_ip <ipaddr> - Enter the IP address of the physical device that
will provide the most direct route to the Internet or other critical network
connections from this virtual router. This must be a real IP address of a
real device on the network. If the connection from the virtual router to
this IP address fails, the virtual router will be disabled automatically. A
new master will be elected from the backup routers participating in the
VRRP group. Different critical IP addresses may be assigned to
different routers participating in the VRRP group, and can therefore
define multiple routes to the Internet or other critical network
connections.
critical_ip_state [enable | disable] - This parameter is used to enable or
disable the critical IP address entered above. The default is disable.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create a VRRP entry:
DGS-3324SRi:4#create vrrp vrid 1 ipif Darren ipaddress 11.1.1.1 state
enable priority 200 advertisement_interval 1 preempt true critical_ip
10.53.13.224 critical_ip_state enable
Command: create vrrp vrid 1 ipif Darren ipaddress 11.1.1.1 state enable
priority 200 advertisement_interval 1 preempt true critical_ip 10.53.13.224
critical_ip_state enable
Success.
DGS-3324SRi:4#
config vrrp vrid
Purpose To configure a VRRP router set on the Switch.
Syntax
config vrrp vrid <vrid 1-255> ipif <ipif_name 12> {state [enable |
disable] | priority <int 1-254> | ipaddress <ipaddr> |
advertisement_interval <int 1-255> | preempt [true | false] |
critical_ip <ipaddr> | critical_ip_state [enable | disable]}
Description This command is used to configure a previously created VRRP
interface on the Switch.
Parameters vrid <vrid 1-255> - Enter a value between 1 and 255 that uniquely
identifies the VRRP group to configure. All routers participating in
this group must be assigned the same vrid value. This value MUST
be different from other VRRP groups set on the Switch.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface to configure a VRRP entry for. This IP interface must be
assigned to a VLAN on the Switch.
state [enable | disable] – Used to enable and disable the VRRP
router on the Switch.
priority <int 1-254> - Enter a value between 1 and 254 to indicate the
router priority. The VRRP Priority value may determine if a higher
priority VRRP router overrides a lower priority VRRP router. A higher
priority will increase the probability that this router will become the
Master router of the group. A lower priority will increase the
probability that this router will become the backup router. VRRP
routers that are assigned the same priority value will elect the