Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
198
DGS-3324SRi:4#config 802.1x capability ports 1:1 – 1:10 authenticator
Command: config 802.1x capability ports 1:1 – 1:10 authenticator
Success.
DGS-3324SRi:4#
config 802.1x auth_parameter
Purpose Used to configure the 802.1x Authentication parameters on a
range of ports. The default parameter will return all ports in the
specified range to their default 802.1x settings.
Syntax
config 802.1x auth_parameter ports [<portlist> | all]
[default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535>| tx_period
<sec 1-65535> | supp_timeout <sec 1-65535> |
server_timeout <sec 1-65535> | max_req <value 1-10> |
reauth_period <sec 1-65535> | enable_reauth [enable |
disable]}]
Description
The config 802.1x auth_parameter command is used to
configure the 802.1x Authentication parameters on a range of
ports. The default parameter will return all ports in the specified
range to their default 802.1x settings.
Parameters
<portlist> − Specifies a range of ports. The port list is specified by
listing the lowest switch number and the beginning port number on
that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
all − Specifies all of the ports on the Switch.
default − Returns all of the ports in the specified range to their
802.1x default settings.
direction [both | in] − Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or
just the receiving direction.
port_control − Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
• force_auth − Forces the Authenticator for the port to
become authorized. Network access is allowed.
• auto − Allows the port’s status to reflect the outcome of
the authentication process.
• force_unauth − Forces the Authenticator for the port to
become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535> − Configures the time interval
between authentication failure and the start of a new
authentication attempt.