Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
181
show ssh user authmode
Purpose Used to display the SSH user setting.
Syntax
show ssh user authmode
Description This command will display the current SSH user setting.
Parameters None.
Restrictions None.
Example usage:
To display the SSH user:
DGS-3324SRi:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts: Authentication
UserName
-------------------------- --------------------------
Trinity Publickey
DGS-3324SRi:4#
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create user account.
config ssh algorithm
Purpose Used to configure the SSH algorithm.
Syntax
config ssh algorithm [3DES | AES128 | AES192 | AES256 |
arcfour | blowfish | cast128 | twofish128 | twofish192 |
twofish256 | MD5 | SHA1 | DSA | RSA] [enable | disable]
This command will configure the desired type of SSH algorithm used
for authentication encryption.
Description
Parameters
3DES – This parameter will enable or disable the Triple_Data
Encryption Standard encryption algorithm.
AES128 - This parameter will enable or disable the Advanced
Encryption Standard AES128 encryption algorithm.
AES192 - This parameter will enable or disable the Advanced
Encryption Standard AES192 encryption algorithm.
AES256 - This parameter will enable or disable the Advanced
Encryption Standard AES256 encryption algorithm.
arcfour - This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish - This parameter will enable or disable the Blowfish
encryption algorithm.
cast128 - This parameter will enable or disable the Cast128
encryption algorithm.