Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
95
DGS-3324SRi:4#show ipfdb
Command: show ipfdb
Interface IP Address Port Learned
------------ --------------- ------ ------------
System 10.0.0.1 1:13 Dynamic
System 10.0.0.2 1:13 Dynamic
System 10.0.0.3 1:13 Dynamic
System 10.0.0.4 1:13 Dynamic
System 10.0.0.7 1:13 Dynamic
System 10.0.0.30 1:13 Dynamic
System 10.0.34.1 1:13 Dynamic
System 10.0.51.1 1:13 Dynamic
System 10.0.58.4 1:13 Dynamic
System 10.0.85.168 1:13 Dynamic
System 10.1.1.1 1:13 Dynamic
System 10.1.1.99 1:13 Dynamic
System 10.1.1.101 1:13 Dynamic
System 10.1.1.102 1:13 Dynamic
System 10.1.1.103 1:13 Dynamic
System 10.1.1.152 1:13 Dynamic
System 10.1.1.157 1:13 Dynamic
System 10.1.1.161 1:13 Dynamic
System 10.1.1.162 1:13 Dynamic
System 10.1.1.163 1:13 Dynamic
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
config fdb destination_hit
Purpose To set the Switch for the FDB destination hit function.
Syntax
config fdb destination_hit [enable | disable]
Description This command will allow the user to enable the Switch as a
destination hit bridge. This destination hit function will keep FDB
entries learned in the forwarding database table from aging out.
When a packet with a destination MAC address is received by the
Switch, the packet will refresh the MAC address in the forwarding
database table once a match has been made, so that it will not age
out.
Parameters [enable | disable] – Used to enable or disable the Switch to be
destination hit ready.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch to be destination hit enabled:
DGS-3324SRi:4#config fdb destination_hit enable
Command: config fdb destination_hit enable
Success.
DGS-3324SRi:4#