Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
239
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the
Switch.
Syntax
show traffic_segmentation <portlist>
Description
The show traffic_segmentation command is used to display the
current traffic segmentation configuration on the Switch.
Parameters
<portlist> − Specifies a range of ports for which the current traffic
segmentation configuration on the Switch will be displayed. The port list
is specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port
3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in numerical order.
Restrictions The port lists for segmentation and the forward list must be on the
same switch.
Example usage:
To display the current traffic segmentation configuration on the Switch.
DGS-3324SRi:4#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- ----------------------------
1:1 1:11-1:15,2:1-2:24
1:2 1:11-1:15,2:1-2:24
1:3 1:11-1:15,2:1-2:24
1:4 1:11-1:15,2:1-2:24
1:5 1:11-1:15,2:1-2:24
1:6 1:11-1:15,2:1-2:24
1:7 1:11-1:15,2:1-2:24
1:8 1:11-1:15,2:1-2:24
1:9 1:11-1:15,2:1-2:24
1:10 1:11-1:15,2:1-2:24
1:11 1:1-1:24,2:1-2:24
1:12 1:1-1:24,2:1-2:24
1:13 1:1-1:24,2:1-2:24
1:14 1:1-1:24,2:1-2:24
1:15 1:1-1:24,2:1-2:24
1:16 1:1-1:24,2:1-2:24
1:17 1:1-1:24,2:1-2:24
1:18 1:1-1:24,2:1-2:24
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All