Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
313
DGS-3324SRi:4# show pim ipmroute
Command: show pim ipmroute
PIM IP Multicast Route Table
UA = Upstream AssertTimer
AM = Assert Metric
AMPref = Assert MetricPref
ARB = Assert RPTBit
Group Address Source Address UA AM AMPref ARB Flag Type
------------------ ------------------ ------ ------ ------ ------ ---- -------
224.0.1.1 31.43.51.81/32 0 0 0 0 rpt (*.G)
224.0.1.24 10.54.81.250/32 0 0 0 0 spt (S.G)
224.0.1.24 10.55.68.64/32 0 0 0 0 spt (S.G)
224.0.1.24 31.43.51.81/32 0 0 0 0 rpt (*.G)
229.55.150.208 10.6.51.1/32 0 0 0 0 spt (S.G)
229.55.150.208 10.38.45.151/32 0 0 0 0 spt (S.G)
229.55.150.208 10.38.45.192/32 0 0 0 0 spt (S.G)
229.55.150.208 10.50.93.100/32 0 0 0 0 spt (S.G)
229.55.150.208 10.51.16.1/32 0 0 0 0 spt (S.G)
229.55.150.208 10.59.23.10/32 0 0 0 0 spt (S.G)
229.55.150.208 31.43.51.81/32 0 0 0 0 rpt (*.G)
239.192.0.1 31.43.51.81/32 0 0 0 0 rpt (*.G)
Total Entries: 12
DGS-3324SRi:4#
create pim register_checksum_include_data
Purpose Used to set the RPs that the Switch will send Register packets to
and create checksums to be included with the data in Registered
packets.
Syntax
create pim register_checksum_include_data rp_ address
<ipaddr>
Description This command will set the RPs that the Switchwill send Register
packets to and create checksums to be included with the data in
Registered packets. This command is for PIM-SM configurations
only.
Parameters rp_address <ipaddr> - Enter the IP address of the RP that will verify
checksums included with Registered packets.
Restrictions Only administrator-level users can use this command.
Usage Example:
To create an RP to which the Switch will send Register packets to and create checksums to be included with the data in
Registered packets: