Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
127
config link_aggregation algorithm
ip_source − Indicates that the Switch should examine the IP source
address.
ip_destination − Indicates that the Switch should examine the IP
destination address.
ip_source_dest − Indicates that the Switch should examine the IP
source address and the destination address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3324SRi:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3324SRi:4#
show link_aggregation
Purpose Used to display the current link aggregation configuration on the
Switch.
Syntax
show link_aggregation {group_id <value 1-32> | algorithm}
Description This command will display the current link aggregation configuration
of the Switch.
Parameters
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm − Specify to display the link aggregation configuration by
the algorithm in use.
Restrictions None.
Example usage:
To display the current Link Aggregation configuration:
DGS-3324SRi:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Master Port : 2:17
Member Port : 1:5-1:10,2:17
Active Port:
Status : Disabled
Flooding Port : 1:5
DGS-3324SRi:4