Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
303
config pim register_suppression_time
Purpose Used to configure the interval between the sending of register packets
for the PIM protocol.
Syntax
config pim register_suppression_time <value 3-255>
Description This command is to be configured for the first hop router from the
source. After this router sends out a register message to the RP, and
the RP replies with a register stop message, it will wait for the time
configured here to send out another register message to the RP. This
command is for PIM-SM configurations only.
Parameters <value 3-255> - The user may set an interval time between 3-255 with
a default setting of 60 seconds for the sending of register suppression
time packets. The default value is 60 seconds.
Restrictions Only administrator-level users can use this command.
Example usage:
To configure the register suppression time:
DGS-3324SRi:4#config pim register_suppression_time 15
Command: config pim register_suppression time_15
Success.
DGS-3324SRi:4#
NOTE: The Probe time value must be less than half of the Register
Suppression Time value. If not, the administrator will be presented with a
Fail message.
create pim crp
Purpose To enable the Switch to become a candidate to be the Rendezvous
Point (RP).
Syntax
create pim crp group <network_address> rp <ipif_name 12>
Description This command will set the parameters for the switch to become a
candidate RP. This command is for PIM-SM configurations only.
Parameters group <network_address> - Enter the multicast group address for
this switch to become a Candidate RP. This address must be a
class D address.
rp <ipif_name 12> - Enter the name of the PIM-SM enabled
interface the switch administrator wishes to become the CRP for
this group.
Restrictions Only administrator-level users can use this command.
Usage Example:
To create an IP interface to become a Candidate RP on the Switch: