Filter
Top Products
LBI-39224
3-71
Site Channel Configuration dialog box
Save
Choose the Save button to perform an immediate save of the currently
selected PIM channel configuration. Other PIMs displayed in the list
box located at the top of the dialog box are not saved. This channel
configuration is saved on the CEC/IMC Manager's hard disk drive.
Any previous channel configuration for the PIM, if present, is erased
and replaced with the current channel configuration. If the CEC/IMC
Manager is running remotely or as a part of the EDACS Network
Manager, this configuration is saved on the CEC/IMC Manager server,
typically local to the CEC/IMC; it is not saved at the remote location.
Save As...
Choose the Save As… button to allow the currently selected PIM
channel configurations to be saved as a different PIM. It is provided to
speed configurations when similar configurations are required. Upon
choosing Save As… a small dialog box (see Figure 17 on page 3-34)
will appear which allows selection of a new PIM number. Select the
desired PIM number from one of the choices in the drop-down list box,
the choices listed are the selected PIMs in the Configured/Active Sites
list box. Like Save, Save As… stores channel configuration on the
CEC/IMC Manager local to the CEC/IMC.
For example, if "Site 8" is the currently selected site-type interface
module and "Site 12" requires similar configuration settings, this button
may be used to save "Site 8" configuration as "Site 12" (save to "12").
The new "site" may then be changed later, as required, by selecting it
from the selection list box, changing the configuration as required, and
then choosing Save.
Close
Choose the Close button to exit the Site Channel Configuration
dialog box and return to the Site Channel Configuration List dialog
box. If any changes have been made and not saved, you will be
prompted (Write Changes to Disk?) to save and exit (Yes), exit
without saving (No), or cancel the Close command and remain in the
dialog box (Cancel).