Filter
Top Products
LBI-39224
3-126
Select All
Choose the
Select All
button to enable all units to be programmed.
All the asterisks on the right should be displayed. This allows the
dispatcher to program any unit. This function is handy when only a few
units will not be allowed to be programmed. Now only those units that
need to be disabled need to be modified.
Save And Send Console Privilege Lists
When the privilege list configuration is complete, the new configuration
must be sent to the console before the new configurations will take
effect. It is important to save the new configuration to the CEC/IMC
Manager hard disk prior to sending it to the console, this ensures that
the actual console configuration is the same as the configuration stored
on the CEC/IMC Manager hard disk. If after making changes, a send is
performed but a save is not, the actual console operation will differ
from the displayed settings upon re-entering the
Console Privilege List dialog box. These actions are performed from
the Console Privilege List dialog box.
Save
Choose the
Save
button to perform an immediate save of the currently
selected console's configuration. Other consoles displayed in the list
box located at the top of the dialog box are not saved. The console
configuration is saved on the CEC/IMC Manager's hard disk drive.
Any previous configuration for the console, if present, is erased and
replaced with the current configuration.
Send
Choose the
Send
button to upload the privilege list data to the console.
The console will need to be on-line for this function to execute
successfully. The entire privilege list will be uploaded to the console.
The user at the console will need to log out and log back in again after
this operation (In case a non-valid module is already programmed).
Close
Choose the
Close
button to exit the Console Privilege List dialog box
and return to the CEC/IMC Manager main window. Any configurations
not saved and sent will be lost unless
Save
and
Send
are performed
first. If any changes have been made and not saved, you will be
prompted (Write Changes to Disk?) to save and exit (
Yes
), exit