Filter
Top Products
LBI-39224
3-196
narrower search parameters. Choose the Send Location Request
button to execute the specified search. The Unit Locations will be
displayed in the list box with their Last Known Location—Group Alias,
GID, Site Alias, and (Site) ID.
Unit Location by Site
When the site is known but the unit is unknown this option can be used
to obtain a list of all units on a particular site. The list can also be
filtered to display only units that are logged onto a particular group or
display all units in all groups on the site of interest. Select the desired
combination of Site and Group from the two drop-down list boxes (Site
Alias & ID and Group Alias & GID) and then choose the
Apply Grp/Site Filter button.
Select the Unit Location By Site option button, select the Site of
interest and a single Group or All Groups from their drop-down lists,
then choose the Apply Grp/Site Filter button to initiate the specific
search parameters. Choose the Send Location Request button to
execute the specified search. The Unit Locations will be displayed in
the list box with their Last Known Location—Group Alias, GID, Site
Alias, and (Site) ID.
If All Groups was selected as the Group search parameter the Unit
Count for the NO GROUP field will display zero, even though many
units may be displayed from the search, because this field displays only
those units belonging to a single particular Group selected in the Group
drop-down list. Also, a "NO GROUP: Unit Count is INVALID"
message will be displayed between the Site and Group drop-down list
boxes for the same reason. If a single Group was selected for a search
parameter, the Unit Count for <selected group> field will display the
number of units found with the specified search parameters, and no
message will be displayed between these list boxes.
Group Location
Group locations are defined as the number of units logged into the
group of interest for each site. Unless the count of units in a group is
zero, calls will always be routed to a secondary site if the site is wide
area enabled. Select the group and site of interest from the Group and
Site drop-down list boxes.
Select the Group Location option button, then select the Group of
interest and a single Site or All Sites from their drop-down lists.