Filter
Top Products
LBI-39224
3-34
Figure 17 "Save As…" Dialog Box
For example, if "Site 8" is the currently selected site-type interface
module and "Site 12" requires similar configuration settings, this button
may be used to save the "Site 8" configuration as "Site 12" (save to
"12"). The new "site" may then be changed later, as required, by
selecting it from the selection list box, changing the configuration as
required, and then choosing Save.
Close
Choose the Close button to exit the Site Channel Configuration
dialog box and enter the Site Channel Configuration List dialog box.
If any changes have been made and not saved, you will be prompted
(Write Changes to Disk?) to save and exit (Yes), exit without saving
(No), or cancel the Close command and remain in the dialog box
(Cancel).
Site Channel Configuration List dialog box
Send
Choose the Send button to send the site channel configuration data to
the respective interface module. This procedure must be performed
before the interface module will operate with the new configuration.
Only configured and configured-and-active (C and C/A prefixes)
configurations may be sent. All configuration data is sent to the MOM
Controller Board; the Audio configuration is sent directly out from
there to the respective interface module Controller Board. A "Send to
Site Successful" message will be received to confirm that the data was
received by the interface module Controller Board. Bus Slot
configuration data is compared to the current configuration at the
CEC/IMC Manager; if different, it is sent to the MOM Controller
Board (if not, no further action is taken by the system) and when the