Filter
Top Products
LBI-39224
3-166
Close
Choose the
Close
button to exit the
Conventional Channel Configuration dialog box and return to the
CEC/IMC Manager main window. Any configuration changes not
saved will be lost; there is no prompt to save any changes before
exiting.
Tone Control/DC Control Configuration ("State Tables,"
Etc.)
Conventional channel Tone Control/DC Control (low-level)
configurations primarily involve "state table" configurations used to
specify tone and DC-controlled signaling requirements. Each
conventional channel has a corresponding state table. In many cases,
state table changes are not necessary since default values match
standard conventional base station remote control signaling
requirements.
The following commands are supported on both tone and DC
configurations.
Table 8 Conventional Base Station Commands
COMMAND DEFINITION
SET TX FREQ 1
Set to transmit on frequency 1.
SET TX FREQ 2
Set to transmit on frequency 2.
SET TX FREQ 3
Set to transmit on frequency 3.
SET TX FREQ 4
Set to transmit on frequency 4.
SET TX FREQ 5
Set to transmit on frequency 5.
SET TX FREQ 6
Set to transmit on frequency 6.
SET TX FREQ 7
Set to transmit on frequency 7.
SET TX FREQ 8
Set to transmit on frequency 8.
SET RX FREQ 1
Set receive frequency to frequency 1.
SET RX FREQ 2
Set receive frequency to frequency 2.
SET RX FREQ 3
Set receive frequency to frequency 3.
SET RX FREQ 4
Set receive frequency to frequency 4.
SET RX FREQ 5
Set receive frequency to frequency 5.
SET RX FREQ 6
Set receive frequency to frequency 6.