Filter
Top Products
LBI-39224
3-139
DVIM Channel Configuration List dialog box is required to save and
send DVIM configurations.
DVIM Channel Configuration dialog box
Save
Choose the Save button to perform an immediate save of the currently
selected DVIM channel configuration. Other DVIMs displayed in the
list box located at the top of the dialog box are not saved. The channel
configuration is saved on the CEC/IMC Manager's hard disk drive.
Any previous channel configuration for the DVIM, if present, is erased
and replaced with the current channel configuration. If the CEC/IMC
Manager is running remotely or as a part of the EDACS Network
Manager, this configuration is saved on the CEC/IMC Manager local to
the CEC/IMC; it is not saved at the remote location.
Save As...
Choose the Save As… button to allow the currently selected DVIM
channel configurations to be saved as a different DVIM. It is provided
to speed configurations when similar configurations are required. Upon
choosing Save As… a small dialog box will appear which allows entry
of a new DVIM number. Do not type a number in the Save As drop-
down list box, the DVIM number must be selected from a number in the
drop-down list, the choices displayed are the selected DVIMs in the
Configured/Active Sites list box. Like Save, Save As… stores
channel configuration on the CEC/IMC Manager server.
Close
Choose the Close button to exit the DVIM Channel Configuration
dialog box and return to the DVIM Channel Configuration List dialog
box. If any changes have been made and not saved, you will be
prompted (Write Changes to Disk?) to save and exit (Yes), exit
without saving (No), or cancel the Close command and remain in the
dialog box (Cancel).
DVIM Channel Configuration List dialog box:
Send
Choose the Send button to send the channel configuration data to the
respective DVIM interface module. This procedure must be performed
before the DVIM will operate with the new configuration. Only
configured and configured-and-active (C and C/A prefixes)
configurations may be sent. All configuration data is sent to the MOM