Filter
Top Products
LBI-39224
3-63
action is taken by the system) and when the MOM Controller Board
receives this new data it will send an acknowledgment message back to
the CEC/IMC Manager, which will then display the confirmation box:
"Do you want to activate TDM Bus Slots? OK - will cause all CTRL
boards to reset." Choose OK to activate TDM Bus Slots (resetting
Controller Boards) with the new Bus Slot configuration data, choose
Cancel to not activate TDM Bus Slots with the new Bus Slot
configuration data (keeping the previous configuration) and return to
the T1/E1 Interface Card Auto-configuration dialog box.
T1/E1 Digital Site Configuration dialog box
Save
Choose the Save button to perform an immediate save of the currently
selected site-type interface module's channel configuration. This
channel configuration is saved on the CEC/IMC Manager's hard disk
drive. Any previous channel configuration for the "site," if present, is
erased and replaced with the current channel configuration. If the
CEC/IMC Manager is running remotely or as a part of the EDACS
Network Manager, this configuration is saved on the CEC/IMC
Manager server, typically local to the CEC/IMC; it is not saved at the
remote location.
Save As...
Choose the Save As… button to allow the currently selected site-type
interface module channel configurations to be saved as a different site-
type interface module. It is provided to speed configurations when
similar NIM configurations are required. Upon choosing Save As… a
small dialog box, similar to Figure 17 on page 3-34, will appear which
allows selection of a new NIM number. Select the desired NIM number
from one of the choices in the displayed list, the choices displayed are
the selected NIMs in the Configured/Active Sites list box. Like Save,
Save As… stores channel configuration on the CEC/IMC Manager
server.
Close
Choose the Close button to exit the T1/E1 Digital Site Configuration
dialog box. If any changes have been made and not saved, a prompt
will appear to warn of the unsaved changes and the user will be given
the opportunity to save and exit (Save)or exit without saving the
changes (Cancel).