Filter
Top Products
Chapter 2. Configuring and Monitoring APPN
This chapter describes the APPN configuration and monitoring commands. It
includes the following sections:
v “APPN Configuration Command Summary”
v “APPN Configuration Command Detail” on page 83
Accessing the APPN Configuration Process
Use the following procedure to access the APPN
configuration
process.
1. At the * prompt, enter talk 6. The Config> prompt is displayed.
(If this prompt is not displayed, press Return again.)
2. Enter protocol appn. The APPN Config> prompt is displayed.
3. Enter an APPN configuration command.
APPN Configuration Command Summary
Table 3. APPN Configuration Command Summary
Command Function See page:
? (Help) Displays all the commands available for
this command level or lists the options for
specific commands (if available). See
“Getting Help” on page xxvi.
Enable/Disable Enables/disables the following: 83
APPN
Dependent LU Requestor
Port
port name
Set Sets the following:
Node 83
Traces 102
HPR 89
DLUR 93
Management 121
Tuning 97
Add Adds or updates the following:
Port
port name
125
Link-station
link station name
149
LU-Name
LU name
173
Connection-network
connection network
name
174
Additional-port-to-connection-network 185
Mode 183
Focal_point 186
local-pu 186
Routing_list 188
COS_mapping_table 191
© Copyright IBM Corp. 1994, 1998 81