Filter
Top Products
Chapter 6. Configuring and Monitoring VINES
This chapter describes the VINES configuring and monitoring commands and
includes the following sections:
v “Accessing the VINES Monitoring Environment” on page 245
v “VINES Monitoring Commands” on page 245
Accessing the VINES Configuration Environment
To access the VINES configuration environment, enter the following command at
the Config> prompt:
Config> protocol vin
VINES Protocol user configuration
VINES Config>
VINES Configuration Commands
This section summarizes and then explains the VINES configuration commands.
Enter these commands at the VINES config> prompt.
Table 55. VINES Configuration Commands Summary
Command Function
? (Help) Displays all the commands available for this command level or
lists the options for specific commands (if available). See “Getting
Help” on page xxvi.
Add Adds an X.25 address translation.
Delete Deletes an X.25 address translation.
Disable Disables the VINES protocol on all interfaces or a single interface
and disables checksumming.
Enable Enables the VINES protocol on all interfaces or a single interface
and enables checksumming.
List Displays the current VINES configuration.
Set Assigns the network addresses to routers in the VINES network
and sets the maximum number of physical neighbor client and
service nodes.
Exit Returns you to the previous command level. See “Exiting a Lower
Level Environment” on page xxvii.
Add
Adds an X.25 address translation.
Syntax:
add
interface ...
# Specifies the interface number.
remote-X.25-addr
Can include up to 15 digits. If the virtual circuit connection has been
configured as PVC, the VINES
remote-X.25-addr
must match the PVC
address configured at the X.25 prompt. If the addresses do not match, the
system defaults to a switched virtual circuit (SVC).
© Copyright IBM Corp. 1994, 1998 241