Filter
Top Products
PIM6>clear
Mfwd Cache has been cleared!
PIM6>
Interface
Use the interface command to display a summary of the statistics and parameters
related to the interface.
Syntax:
interface
Example:
PIM6>interface
PIM Interface Table
Hello State
IP Address Interval Holdtime Status Type
1:2:3:4:5:6::101 30 210 up TKR/0
1:2:5:6:7::102 30 210 up TKR/1
PIM6>
IP address
Specifies the IP address of the interface.
Hello interval
Specifies the number of seconds between hello messages on this interface.
State holdtime
Specifies the number of seconds upstream devices are informed to hold
state information before discarding. For PIM, this is the number of seconds
a prune is active upstream.
Status
Specifies the current status of the interface.
up The interface is up and fully operational, but does not generate the
mld queries.
disabled
The interface is operational but is disabled and PIM is not active.
down The interface is not operational.
Join
Use the join command to join a multicast group.
Syntax:
join
Example:
PIM6>join ff05:42::101
PIM Monitoring Commands (Talk 5)
Chapter 16. Configuring and Monitoring Protocol Independent Multicast Routing Protocol (PIM) 417
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
||
|
|
|
|
|
|
|