Filter
Top Products
Table 20. Configuration Parameter List - Port Default TG Characteristics (continued)
Parameter Information
Parameter
Effective capacity
Valid Values
2 hexadecimal digits in the range X'00' to X'FF'
Default Value
FR: X'45' (64 Kbps)
PPP: X'45' (64 Kbps)
DLSw: X'75' (4 Mbps)
SDLC: X'45' (64 Kbps)
X.25: X'45' (64 Kbps)
TR: X'85' (16 Mbps)
TR: X'75' (4 Mbps)
ENET: X'80' (10 Mbps)
For ATM SVCs (25 Mbps) and ATM PVCs (25Mbps):
Campus ATM best effort: X'8A'
Campus ATM reserved: X'8A'
WAN ATM best effort: X'8A'
WAN ATM reserved: X'8A'
For IP:
Campus: X'75'
WAN: X'43'
Description
This parameter specifies the effective capacity TG characteristic for all associated
connections (TGs) on this port.
This parameter specifies the maximum bit transmission rate for both physical links and
logical links. Note that the effective capacity for a logical link may be less than the
physical link speed. The rate is represented in COS files as a floating-point number
encoded in a single byte with units of 300 bps. The effective capacity is encoded as a
single-byte representation. The values X'00' and X'FF' are special cases used to denote
minimum and maximum capacities. The range of the encoding is very large; however,
only 256 values in the range may be specified.
This parameter provides the default value for the Effective capacity parameter on the
Modify TG Characteristics Command Line option. The Modify TG Characteristics
Command Line option enables you to override the .* default values assigned to TG
characteristics on the individual link stations you define.
APPN Configuration Commands
144
MRS V3.2 Protocol Config Ref Vol 2