Filter
Top Products
-t TP name
Default Value: APING
-i Count of sends and receives to issue
Default Value: 1
-x Count of conversations to run
Default Value: 1
-y Count of TPs to run
Default Value: 1
-s Size of packet
Default Value: 100
-q Quiet
-b Background display goes to talk 2
lu_name
Specifies the fully-qualified LU name of the target of the APING.
Valid Values: Any valid fully-qualified LU name
Default Value: None
Dump
Use the Dump command to create an APPN dump. You can use Boot config> on
talk 6 to determine where the dump will be saved. The dump name will be the
same as the dump of the whole router with ’_A.1’ concatenated to the end. You can
initiate multiple dumps. The concatenation will be incremented for each dump.
When the dump name has reached ’_A.5’, it will be reset to ’_A.1’.
Syntax:
dump
You can check the size on the dump server to know when the dump finishes.
The router continues to execute while the dump occurs.
List
Use the List command to display information about the APPN configuration. The
command lists:
Syntax:
list
name
Command Function
List cp Displays a table of all cp sessions.
List isr Displays a table of all defined active ISR transmission groups.
List session_info
Displays origin CP Name, primary LU Name and secondary LU
Name if
Save RSCV information for intermediate sessions
is Yes.
APPN Monitoring Commands
210
MRS V3.2 Protocol Config Ref Vol 2