Filter
Top Products
Cost Specifies the cost associated with the tunnel which will be used
during route lookups to find the best route to the destination.
Valid Values:1-255
Default Value:1
TTL value
Specifies the time-to-live value used in frames encapsulated for this
tunnel
Valid Values: Any numeric value in the range of1-255
Default Value:64
Allow fragmentation in the tunnel?
Specifies whether the fragmentation in the tunnel will be allowed.
Specifying
yes
allows fragmentation in the tunnel in case the IPv4
network that the tunnel is using does not provide enough
information to allow the device to return a “Packet Too Big”
message to the IPv6 host.
Valid Values: yes or no
Default Value:no
Change
Use the change command to add an IPv6 address, leaked routes, packet filters,
routes, or tunnels.
Syntax:
change
address
net address prefix
leaked-routes
destination
packet-filter
name interface
route
destination mask gateway cost ...
tunnel
destination prefix raddress locaddress cost ttl
fragmentation
address
Changes an address.
leaked-routes
Changes a leaked route configuration.
packet-filter
Changes a packet filter configuration.
route Changes a route configuration.
tunnel Changes a tunnel configuration.
See “Add” on page 383 for a description of the parameters associated with the
change command.
Delete
Use the delete command to remove an address, leaked-routes, packet filter, route
or tunnel.
IPV6 Configuration Commands (Talk 6)
Chapter 14. Configuring and Monitoring IPV6 387
||
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
||
||
||
||
|
|
|
|
|
|
|
||
||
|
|
|
|
|