Filter
Top Products
Syntax:
set
dlur
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table 7. Configuration Parameter List - Dependent LU Requester
Parameter Information
Parameter
Enable dependent LU requester (DLUR) on this network node
Valid Values
Yes, No
Default Value
No
Description
This parameter specifies whether a dependent LU requester is to be functionally
enabled on this node.
Parameter
Default fully-qualified CP name of primary DLUS (required when DLUR is enabled)
Valid Values
A string of up to 17 characters in the form of
netID.CPname
, where:
v
netID
is a network ID from 1 to 8 characters
v
CPname
is a CP name from 1 to 8 characters
Each name must conform to the following rules:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: An existing fully-qualified CP name, using the special characters @, $, and #
from the character set A, continues to be supported; however, these characters should
not be used for new CP names.
Default Value
None
Description
This parameter specifies the fully-qualified control point (CP) name of the dependent
LU server (DLUS) that is used by default. The default primary server may be
overridden on a link station basis. The default server is used for incoming requests
from downstream PUs when a primary DLUS has not been specified for the associated
link station.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 93