Filter
Top Products
Table 26. Configuration Parameter List - Modify Dependent LU Server
Parameter Information
Parameter
fully-qualified CP name of primary DLUS
Valid Values
A string of up to 17 characters in the form of
netID.CPname
, where:
v
netID
is a network ID from 1 to 8 characters
v
CPname
is a control point name from 1 to 8 characters
Each name must conform to the following rules:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: An existing fully-qualified CP name, using the special characters @, $, and #
from the character set A, continues to be supported; however, these characters should
not be used for new CP names.
Default Value
The value specified in the default fully-qualified CP name of primary dependent LU
server parameter.
Description
This parameter specifies the fully-qualified CP name of the dependent LU server
(DLUS) that is to be used for incoming requests from the downstream PU associated
with this link station.
Parameter
fully-qualified CP name for backup DLUS
Valid Values
A string of up to 17 characters in the form of
netID.CPname
, where:
v
netID
is a network ID from 1 to 8 characters
v
CPname
is a control point name from 1 to 8 characters
Each name must conform to the following rules:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: An existing fully-qualified CP name, using the special characters @, $, and #
from the character set A, continues to be supported; however, these characters should
not be used for new CP names.
Default Value
The value specified in the default fully-qualified CP name of backup dependent LU
server parameter.
Description
This parameter specifies the fully-qualified CP name of the dependent LU server
(DLUS) that is to be used as a backup for the downstream PU associated with this link
station. This parameter allows the default backup server to be overridden. A backup is
not required, and the NULL value indicates the absence of a backup server. Note that
NULL can be specified even when a default backup server has been defined (by
erasing the default value that appears for this parameter).
APPN Configuration Commands
168
MRS V3.2 Protocol Config Ref Vol 2