Filter
Top Products
add
interface#
interface#
Specifies the interface to which RIP6 protocol is to be added.
Note: This interface must have an IPV6 address configured or be the
virtual interface of an IPV6 over IPV4 tunnel.
Valid Values: Any valid interface number
Default Value: None
Change
Use the change command to change a RIP6 metric.
Syntax:
change
rip6-in-metric
rip6-out-metric
rip6-in-metric
Changes the value of the RIP6 metric for the incoming RIP6 updates.
Change RIPng metric on which interface?
Specifies the interface number on which RIP6 input metric is to be
changed.
Note: The interface must have RIP6 configured.
Valid Values: Any valid interface number
Default Value: 0
RIP6 input Metric
Changes the value of the RIP6 metric on incoming RIP6 updates.
Valid Values: 1-15
Default Value: 1
rip6-out-metric
Changes the RIP6 metric on the outgoing RIP6 updates.
Change RIPng metric on which interface?
Specifies the interface number on which RIP6 output metric is to be
changed.
Note: The interface must have RIP6 configured.
Valid Values: Any valid interface number
Default Value: 0
RIP6 output Metric
Specifies the value of the RIP6 metric on outgoing RIP6 updates.
Valid Values: 0-15
Default Value: 0
RIP6 Configuration Commands (Talk 6)
426
MRS V3.2 Protocol Config Ref Vol 2
||
|
|
|
|
|
|
|
|
|
||
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|