Filter
Top Products
IPV6 config>list tunnel
Tun# Remote Endpoint Local Endpoint Frag Allowed TTL Cost Net# IPv6 Address/Prefix
1 1.2.3.4 2.3.4.5 No 100 100 7 1:2:3:4:5:6:7:8/128
IPV6 config>
Set
Use the set command to set configuration parameters.
Syntax:
set
access-control
automatic-tunnel-parameters
ttl fragmentation
hopcount
cache-size
#entries
default
...
internal-ip-address
mld
...
path-mtu-aging-timer
reassembly-size
router-id
routing
#nets
ttl
Example:
IPV6 config>set au
TTL value [64]?
Allow fragmentation in tunnel?(Yes or [No]):
IPV6 config>set ca
number of cache entries [64]?
IPV6 config>set mld query-interval
Network interface [0]? 5
New Query Interval (in secs) [125]?
IPV6 config>set mld response-interval
Network interface [0]? 5
New Response Interval (in secs) [10]?
IPV6 config>set mld robust
Network interface [0]? 5
New Robustness Variable [2]?
IPV6 config>set mld leave
Network interface [0]?
New Leave Interval (in secs) [1]?
IPV6 config>?
access-control
Specifies whether access control is enabled or disabled.
Valid Values: on or off
Default Value: off
IPV6 Configuration Commands (Talk 6)
Chapter 14. Configuring and Monitoring IPV6 391
|
|
|
|
|
|
|
||
||
|
||
||
||
||
||
||
||
||
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|