Filter
Top Products
packet-filter name
Specifies the name of the packet-filter to be enabled. This name is
configured using the add packet-filter command.
Valid Values: Any valid IPv6 address
Default Value: None
path-mtu-discovery
Enables Path MTU Discovery, a protocol that allows a host node to
determine the maximum size packet that will traverse a path to a
destination without fragmentation.
List
Use the list command to display the IPV6 configuration.
Syntax:
list
all
addresses
icmp-redirect
leaked-routes
mld
packet-filter
routes
sizes
tunnels
Example:
IPV6 config>list all
Interface addresses
IPV6 addresses for each interface:
intf 0 IP disabled on this interface
intf 1 IP disabled on this interface
intf 2 IP disabled on this interface
intf 3 IP disabled on this interface
intf 4 IP disabled on this interface
intf 5 1234:1234:1234:1234:5234:6234:7234:8234/128
1223::7:1234/8
Router-ID: 1::9
Internal IP address: 1::8
Routing
route to: 1234::1223/128
via: 1234:0:9::8 cost: 100
via: 1234:0:9:8:8:7:6:8 cost: 232
via: 1:2:3:4:5:6:7:8 cost: 1
via: 8:7:6:5:4:3:2:1 cost: 1
route to: ::/0
via: 1::8 cost: 100
route to: 2::8:9/8
via: 1::8 cost: 1
Path MTU Discovery: disabled
IPV6 Configuration Commands (Talk 6)
Chapter 14. Configuring and Monitoring IPV6 389
|
|
|
|
|
|
|
|
|
|
|
|
||
||
||
||
||
||
||
||
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|