Filter
Top Products
Table 23. Configuration Parameter List - Link Station - Detail (continued)
Parameter Information
Parameter
Preferred Network Node Server
Valid Values
YesorNo
Default Value
No
Description
This parameter indicates whether this uplink is to a network node server that is to be
used as the network node server for the node supporting Branch Extender function and
acting as an end node. If
yes
is specified, this uplink will be used as the network node
server for this node.
This question will be asked only if:
v Enabled Branch Extender is
yes,
v This station is a network node,
v Branch Uplink is
yes
, and
v CP-CP sessions are supported on this link.
Parameter
TG Number
Valid Values
If
limited resource
is Yes, valid values are 1 - 20. If
limited resource
is No and
link type
is X.25 SVC, valid values are0-20.
Otherwise, valid values are0-20.
Default Value
If
limited resource
is Yes, default is 1. If
limited resource
is No, default is 0.
Otherwise, default value is 0.
Description
This parameter uniquely identifies a TG between adjacent nodes.
Parameter
Solicit SSCP session
Valid Values
YesorNo
Default Value
No
If the link station name is the same as the CP name, then the default is
yes
.
Description
This parameter indicates whether this link is to solicit SSCP sessions.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 157
|
|