Filter
Top Products
Table 37. Configuration Parameter List - Routing List Configuration (continued)
Parameter Information
Parameter
Routing CP and optional subnet visit count
Valid Values
A fully-qualified CP name consisting of 1 to 17 characters followed by an optional
numeric subnet visit count. Legal characters for the CP name are: A-Z, @, $, #, 0-9
The first character of the NETID part and of the CP name part must be non-numeric.
The optional subnet visit count range is 1 to 255 and should be separated from the
fully-qualified CP name by one or more spaces.
Default Value
Blank for fully-qualified CP name and node-level setting for subnet visit count.
Description
This parameter specifies a list of one or more fully-qualified CP names of CPs that
might know how to reach one or more of the previously configured destination LUs.
Each of the following special keywords may be used once in any given routing list:
v “*” - equivalent to specifying all native BNs, all adjacent non-native BNs, and all
adjacent non-native NNs.
v “*SELF” - equivalent to specifying the local node’s fully-qualified CP name
v “*EBNS” - equivalent to specifying all native BNs
This question will be repeated until terminated with a null entry.
Notes:
1. All the editing shortcuts described at the beginning of this table are available to
speed modification of a previously configured routing CP list.
2. If you configure “*SELF” as a CP name, you cannot configure the local node’s CP
name.
3. Any given routing list can have the following maximum number of CP names and
keywords:
v 2210 12x - not supported
v 2210 14x or 24x - 96
4. Across all routing lists, you may use no more than the following number of different
CP names and keywords:
v 2210 12x - not supported
v 2210 14x or 24x - 96
5. Any given CP name or keyword may appear in no more than 255 routing lists.
Syntax:
add
cos_mapping_table
Note: These questions are asked only if you have configured the node as
a border node.
COS mapping tables are not supported for 2210 12x models.
The editing shortcut keys specified at the beginning of the routing list
table are also valid here. Use them to speed modification of the
non-native CP names and COS name pairs.
APPN Configuration Commands
190
MRS V3.2 Protocol Config Ref Vol 2