Filter
Top Products
Table 28. Configuration Parameter List - Modify HPR Defaults (continued)
Parameter Information
Parameter
Reply timer override for HPR (HPR T1)
Valid Values
1 to 254 half-seconds
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the HPR override LLC reply timer (HPR T1) that is to be used
when HPR is supported by this link station. This parameter overrides the value taken
from the default reply timer override for HPR parameter specified on HPR Defaults.
This parameter supersedes the value of the LLC reply timer (T1) parameter specified
on the Modify Logical Link Control (LLC) Characteristics parameter when HPR is
supported.
Parameter
Maximum number retransmission (HPR N2)
Valid Values
1 to 2 160 000
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the HPR override LLC maximum number of retransmissions
(HPR N2) that is to be used when HPR is supported by this link station. This parameter
overrides the value taken from the default maximum number of retransmissions for
HPR parameter specified on the HPR LLC Override defaults.
This parameter supersedes the value of the LLC maximum number of retransmissions
(N2) parameter specified on the Modify Logical Link Control (LLC) Characteristics
parameter when HPR is supported.
Parameter
Limited Resource Timer
Valid Values
1 to 216000 seconds
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the timer value associated with the limited resource.
Syntax:
add
lu-name
You will be prompted to enter a station name to associate this LU with.
You will be prompted to enter a value for the following parameter. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
APPN Configuration Commands
172
MRS V3.2 Protocol Config Ref Vol 2