Filter
Top Products
Example:
send
Destination NSAP: []?
Subnets
Use the subnets command to display information on all operational subnets.
Subnets that are down or disabled will not be listed.
Syntax:
subnets
Example:
subnets
L2
Hdw Int # Circ Only ES-IS IS-IS L1DR L1Pri L2DR L2pri Cost Ext
PPP/2 2 3NNY
Eth/0 0 1NYY Y64N 6420N
Hdw The type and instance of the network that connects to the subnet.
Int # The router’s interface number that connects to the subnet.
Circ The circuit assigned ID for the ISIS protocol.
L2 only
Whether this router is a level 2 router only, Y (yes) or N (no).
ES-IS The ES-IS protocol is enabled on the subnet, Y or N.
IS-IS The IS-IS protocol is enabled on the subnet, Y or N.
L1DR This router is the level 1 designated router for this subnet, Y or N.
L1Pri The subnet’s level 1 priority for becoming the designated router.
L2DR This router is the level 2 designated router for this subnet, Y or N.
L2Pri The LAN subnet’s level 2 priority for becoming the designated router.
Cost The cost of the circuit.
Ext Whether the subnet is operating outside the IS-IS routing domain (external).
Toggle (Alias/No Alias)
Use the toggle alias/no alias command to enable or disable the NSAP alias display
function for the OSI protocol.
Syntax:
toggle
Example:
toggle
Alias substitution is ON
Traceroute
Use the traceroute command to track the path an OSI packet takes to a
destination.
OSI/DECnet V Monitoring Commands (Talk 5)
Chapter 10. Configuring and Monitoring OSI/DECnet V 343