Filter
Top Products
Example:
ap2config>disable nfilter in
Interface # [0]? 2
nfilter out
interface#
Disables, but does not delete, the output network filters on this interface.
Example:
ap2config>disable nfilter out
Interface # [0]? 2
zfilter in
interface#
Disables, but does not delete, the input zone filters on this interface.
Example:
ap2config>disable zfilter in
Interface # [0]? 1
zfilter out
interface#
Disables, but does not delete, the output zone filters on this interface.
Example:
ap2config>disable zfilter out O
Interface # [0]? 1
split-horizon-routing
interface#
Disables split-horizon-routing on this interface. You need to disable
split-horizon routing only on Frame Relay interfaces that are on a hub in a
partially-meshed Frame Relay network. Disabling split-horizon routing
causes all of the routing tables to be propagated on this interface.
Example:
ap2config>disable split-horizon-routing 0
Enable
Use the enable command to enable the checksum function, to enable a specified
interface, to enable AppleTalk 2 gateway function, or to globally enable the
AppleTalk Phase 2 protocol.
Syntax:
enable
ap2
checksum
interface...
nfilter in...
nfilter out...
split-horizon-routing...
zfilter...
ap2 Enables the AppleTalk Phase 2 packet forwarder over all of the interfaces.
Example:
ap2config>enable ap2
checksum
Specifies that the router will compute the checksum in packets it generates.
The router checksums all AP2 packets it forwards.
Example:
AppleTalk Phase 2 Configuration Commands (Talk 6)
Chapter 4. Configuring and Monitoring AppleTalk Phase 2 225