Filter
Top Products
Table 17. Configuration Parameter List - Port Configuration (continued)
Parameter Information
Parameter
Limited Resource ( PPP and FR over dial circuits only)
Valid Values
Yes, No
Default Value
If the dial circuit is
dial on demand
, the default is Yes. Otherwise, the default is No.
Description
This parameter specifies whether link stations on this port are a limited resource. This
value may be overridden on the link station definition.
Parameter
Support bridged formatted frames (Frame relay only)
Valid Values
Yes, No
Default Value
No
Description
This parameter specifies whether the frame relay port will support bridged formatted
frames.
If you are configuring frame relay to support bridged format, you will also need to
configure a boundary node identifier.
Parameter
Boundary node identifier (frame relay only)
Valid Values
X’0000 0000 0001’ to X’7FFF FFFF FFFF’
Default Value
X’4FFF 0000 0000’
Description
This parameter specifies the boundary node identifier MAC address. The router uses
this MAC address to recognize that the frame is a frame relay bridged frame destined
for APPN.
Parameter
Subnet visit count
Valid Values
1 - 255
Default Value
Default taken from the equivalent node level parameter
Description
This parameter specifies this port’s default for the maximum number of subnetworks
that a multi-subnet session may traverse.
Note: This question is asked only if the border node function is enabled on this node.
APPN Configuration Commands
128
MRS V3.2 Protocol Config Ref Vol 2