Filter
Top Products
Table 7. Configuration Parameter List - Dependent LU Requester (continued)
Parameter Information
Parameter
Short retry count
Valid Values
0to65535
Default Value
5
Description
In all cases of pipe failure other than non-disruptive UNBIND, this parameter specifies
the number of times the DLUR will attempt to perform short retries to reach the DLUS
after an attempt to establish this connection has failed.
See “DLUR Retry Algorithm” on page 41 for a complete description of the retry
algorithm.
Parameter
Perform long retries to restore disrupted pipe
Valid Values
Yes, No
Default Value
If
Perform retries to restore disrupted pipes
is Yes, then the default value is Yes.
Otherwise, the default is No
Description
See “DLUR Retry Algorithm” on page 41 for a complete description of the retry
algorithm.
Parameter
Long retry timer
Valid Values
0 to 2 756 000 seconds
Default Value
300 seconds
Description
This parameter specifies the time DLUR will wait when performing long retries.
See “DLUR Retry Algorithm” on page 41 for a complete description of the retry
algorithm.
Syntax:
set
tuning
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Note: You will have to re-boot in order for the changes you specify to take
place.
APPN Configuration Commands
96
MRS V3.2 Protocol Config Ref Vol 2