IBM SC30-3865-04 Network Router User Manual


 
-------------------------------------------------------------
COS:
COS NAME
--------
BATCH
BATCHSC
CONNECT
INTER
INTERSC
CPSVCMG
SNASVCMG
MODE NAME COS NAME
---------------------
PORT:
INTF PORT LINK HPR SERVICE PORT
NUMBER NAME TYPE ENABLED ANY ENABLED
------------------------------------------------------
0 TR000 IBMTRNET YES YES YES
**** < this is the Primary port
1 FR001 FR YES YES YES7
**** < this is the alternate port
4 PPP004 PPP YES YES YES 8
STATION:
STATION PORT DESTINATION HPR ALLOW ADJ NODE
NAME NAME ADDRESS ENABLED CP-CP TYPE
------------------------------------------------------------
TONN25 FR001 132 YES YES 0
TONN31 FR001 141 YES NO 0
TONN103 FR001 153 YES NO 0
**** < this is the alternate to NN6
TONN6WRR PPP004 000000000000 YES YES 0 9
**** < this is the Primary to NN1
TONN1PRI FR001 121 YES YES 0 10
LU NAME:
LU NAME STATION NAME CP NAME
------------------------------------------------------------
APPN config> ex
************************************************************************
************************************************************************
************************************************************************
Config>
************************************************************************
**** The configuration is NN22---primary FR
**** ---Alternate WRR to NN6
****
** This is the NN6 configuration which is the destination side for the
* NN22 Wan Reroute
* interface 17 has the ISDN lid for 2210-22 so when NN22 calls into NN6,
* it will map to interface 17
*
************************************************************************
11
Config> n17
Circuit configuration
FR Config>fea li all
Base net = 6
Destination name = 2210-22
Circuit priority = 8
Inbound destination name = 2210-22
Inbound calls = allowed
Idle timer = 0 (fixed circuit)
SelfTest Delay Timer = 150 ms
FR Config>ex
**** on this side, the interface must be ENABLED all the time
Config>ena in 17
Interface enabled successfully
************************************************************************
* Define the APPN PORT; NN22 will call into NN6 and dynamically create
* the linkstation when NN22 does a Wan Reroute.
*
************************************************************************
Config>p appn
APPN user configuration
APPN
Chapter 1. APPN 57