Filter
Top Products
router priority
Router priority for this circuit, used in vying for designated router
status.
router type
Router type for this circuit - standard, phase IV with AMA, or
Bilingual.
maximum routers
Maximum number of routers allowed on this circuit.
state Either ON or OFF. In the volatile database, the state will be ON if
the circuit is enabled, and is passing self-test. If the circuit has
failed self-test, or the device is not present, the state will be OFF.
In the permanent database, this tells if DNA will try to enable the
circuit.
executor
argument
Retrieves information on the current state of the volatile database for DNA
with the show executor command. The list executor command retrieves
the data which is stored in the permanent data base for DNA.
The following lists the subcommand options or arguments you select from
after you enter the show/list executor command:
characteristics
The detailed information on the settings of all of the adjustable
arguments of the routing database.
counters
Gives the global event and error counters for DNA. There are no
permanent counters, so the list executor counters command is
irrelevant.
status Gives key information on the state of DNA.
summary
Gives a brief summary on the state of DNA. This is the default.
Example:
show executor
Node Volatile Summary
Executor node = 2.26 (gato)
State = on
Identification = DECnet-MC68360 V1 R2.0 NP00523 [P10]
Example:
show executor characteristics
This example shows the full configuration of the router’s database. The list
executor characteristics command produces essentially the same display.
Node Volatile Characteristics
Executor node = 2.26 (gato)
State = on
Identification = DECnet-MC68360 V1 R2.0 NP00523 [P10]
Physical address = AA-00-04-00-1A-08
Type = DEC-area
Routing version = V2.0.0
Broadcast routing timer = 180
Maximum address = 64
Maximum cost = 1022
Maximum hops = 30
Maximum visits = 63
Maximum area = 63
Max broadcast nonrouters = 64
Max broadcast routers = 32
DNA IV Configuration and Monitoring Commands
280
MRS V3.2 Protocol Config Ref Vol 2