Filter
Top Products
Default Value:1
Move record after record number
Specifies target location in the access-control list. You will be asked
to verify that this is the action you want to configure.
Valid Values: 1 to the number of access control records defined for
this packet filter
Default Value:0
List
Use the update packet-filter list command to display the access control list
configuration.
Syntax:
list
access-controls
Example:
Packet-filter 'x' Config> li acc
Access control is : enabled
List of access control records:
1 Type=IS Source=2001:1::6101/128
Dest= 2001:1::86/128
Tid=3
2 Type=I Source=::/0
Dest=::/0
Packet-filter 'x' Config>
Accessing the IPV6 Monitoring Environment
Use the following procedure to access the IPV6 monitoring commands. This
process gives you access to the IPV6 monitoring process.
1. At the OPCON prompt, enter talk 5. (For more detail on this command, refer to
the chapter entitled “The OPCON Process and Commands” in the
Software
User’s Guide
.) For example:
* talk 5
+
After you enter the talk 5 command, the GWCON prompt (+) displays on the
terminal. If the prompt does not appear when you first enter configuration, press
Return again.
2. At the + prompt, enter the p ipv6 command to get you to the ipv6> prompt.
Example:
+ p ipv6
ipv6>
IPV6 Configuration Commands (Talk 6)
Chapter 14. Configuring and Monitoring IPV6 397
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|