Filter
Top Products
Table 4. Configuration Parameter List - APPN Routing (continued)
Parameter Information
Parameter
Network ID (required)
Valid Values
A string of 1 to 8 characters:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: A network identifier for an existing network, of which this router network node is
to become a member, using the special characters @, $, and # from the character set
A, continues to be supported; however, these characters should not be used for new
network IDs.
Default Value
None
Description
This parameter specifies the name of the APPN network to which this network node
belongs. The network ID must be the same for all network nodes in the APPN network.
Attached APPN end nodes and LEN end nodes can have different network IDs.
Parameter
Control point name (required)
Valid Values
A string of 1 to 8 characters:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: An existing CP name that this node would be acquiring, using the special
characters @, $, and # from the character set A, continues to be supported; however,
these characters should not be used for new CP names.
Default
None
Description
This parameter specifies the name of the CP for this APPN network node. The CP is
responsible for managing the APPN network node and its resources. The CP name is
the logical name of the APPN network node in the network. The CP name must be
unique within the APPN network identified by the Network ID parameter.
APPN Configuration Commands
84
MRS V3.2 Protocol Config Ref Vol 2