Filter
Top Products
Setting Transmission Conditions - (continued)
2-25
Verification Stamp
When transmitting a fax via the RADF, a stamp can be affixed to the pages of the document
that have already been scanned, allowing you to confirm that these pages have been
scanned. The stamp is a pink circle, 3mm in diameter and affixed at the rear edge on the front
side of the original document. When both sides of a sheet are transmitted, the stamp is affixed
on the front side.
•
The stamp ink must be replaced when it runs out. When color of the verification stamp
becomes light, contact your service representative for a replacement.
• When mixed original mode is selected, no stamp may be affixed to the above position.
• Even though the Verification Stamp function has been set, no Verification Stamp is put
though the document is transmitted through multi-feeding. In such a case, transmit the
document again.
• Check if the document was correctly transmitted by the Transmission Report or Transmit
Result of the CHECK MODE.
• For detail about replacing the stamp, refer to "Replacing the Stamp" (p. Appendix-5).
Stamp position
Front surface of
original document
Original document
transmitting direction
DETAILS
Simple Internet
Fax Transmission
Transmi tt ing Do cument s to
Internet Fax/Computer
Transmitting to Both
Co nven tio na l F ax an d E-Mail
Placing the Original
on the Machine
Setting Transmission
Conditions
Method for Specifying
Ad dress e s
Scanning
Canceling
Transmission
Confirming Reserved
Do cum en ts
Con firming
Commu nication Result s