Filter
Top Products
DEFINITYEnterpriseCommunicationsServerandSystem75andSystem85
Terminals and Adjuncts Reference
555-015-201
Issue 11
December 1999
The 8400 Series Voice Terminals
12-62The 8411 Voice Terminal
12
NOTE:
When the 8411 is programmed for the Analog Adjunct to use a separate
telephone line (that is, the I2-Channel), the red light is always on.
Sharing the 8411 Telephone Line with the Analog Adjunct
When your 8411 voice terminal has not been assigned a separate telephone
number for your analog adjunct, that is, the telephone line must be shared
between your voice terminal and the analog adjunct connected to the Analog
Adjunct jack, you CANNOT use your 8411 and the analog adjunct at the same
time. If you desire to use your 8411 (the handset, the built-in speakerphone, or
any equipment connected to the Speakerphone/Headset jack) while the analog
adjunct is using the line, you must first disconnect from the analog adjunct call.
You may disconnect from the analog adjunct call manually using a button on the
analog adjunct or use a PC command if the analog adjunct is connected to the
PC. Button #10 can also be used to disconnect the call on the analog adjunct if
that button has been enabled for the disconnect function.
In addition to the manual and Button #10 methods for disconnecting from the
analog adjunct call, going off-hook and pressing the appropriate call appearance
button will also cause the line to be switched to the voice terminal (handset,
speakerphone, or any equipment connected to the Speakerphone/ Headset jack)
and a disconnect signal will be sent to the analog adjunct. This method allows you
to automatically disconnect the analog adjunct to:
■ Answer an incoming call on another call appearance
■ Originate a call on an idle call appearance
■ Interrupt the analog adjunct and use the active call appearance
NOTE:
This feature requires the 8411 to use the first three call appearance/feature
buttons (the top three buttons in the first column) as call appearance
buttons. If there are more than three call appearance buttons administered,
the feature will still work with these (top) three buttons, but NOT with the
additional call appearance buttons.
For incoming calls, the device that answers first (that is, the 8411 handset, 8411
built-in speakerphone, any equipment connected to the Speakerphone/ Headset
jack on the 8411, or the analog adjunct connected to the 8411 Analog Adjunct
jack) gets control of the call. Note that not all incoming calls will cause a ringing
signal to be sent to the analog adjunct. A ringing signal will be sent only if all call
appearances are idle and the incoming call is either an inside call, a DID call, or a
Priority call.