Filter
Top Products
DEFINITYEnterpriseCommunicationsServerandSystem75andSystem85
Terminals and Adjuncts Reference
555-015-201
Issue 11
December 1999
ISDN Voice Terminals
17-34The ISDN 8510 Voice/Data Terminal
17
Kickstand
The kickstand on the bottom of the terminal can be lifted from the desktop stand
or can be left level with the bottom of the terminal. The user should check which
kickstand adjustment allows the best viewing angle of the display.
NOTE:
When the kickstand is raised or lowered, the speakerphone should be
re-calibrated to compensate for the new position.
Ringing
The 8510T has electronic tone ringing with eight possible personalized ringing
patterns that can be selected through the softkeys and the display control buttons.
Ringer volume is controlled by the VOLUME “arrow” button when the terminal is
on-hook.
Jacks
The 8510T voice/data terminal housing contains three jacks. The Handset cord
jack, for connecting the handset to the terminal, is located on the bottom of the
housing, near the front of the terminal. The Line jack, for connecting the line cord
to the terminal, is located on the bottom (left center) of the terminal. The Adjunct
jack, which is located on the bottom of the voice terminal directly below the Line
jack, is used for connecting optional adjunct equipment such as an S201A
Speakerphone or a 500A Headset Adapter to the terminal.
NOTE:
When an ADB (board) is installed in the 8510T terminal for data operations,
the RS232 jack is visible on the rear of the set for connecting data
equipment. When a TMI board is installed in the 8510T, two jacks are visible
on the rear of the set: the RS232 for the data connection and an 8-pin round
connector for connection of a video cable.
Cords
Two cords are supplied with the 8510T: a coiled 9-foot modular Handset cord and
a 7-foot Line cord. An optional 12-foot Handset cord is available.
ADB and TMI Boards
An Asynchronous Data Board (ADB) can be installed in the 8510T for data
applications. A TMI (Telephone Multimedia Interface) board can be installed if the
8510T is to be used as a video terminal.
Mounting Options
The 8510T comes equipped with a desk stand. However, the desk stand can be
removed, and the terminal can be mounted on the wall. If you choose to
wall-mount the voice terminal, use the instructions included in the 8510T Voice
Terminal Wall Mounting Kit (Comcode: 106614894).