DEFINITYEnterpriseCommunicationsServerandSystem75andSystem85
Terminals and Adjuncts Reference
555-015-201
Issue 11
December 1999
Cordless and Wireless Telephones
18-8The MDC 9000 Cordless Telephone
18
equipment, phone system control units, uninterruptible power supplies,
copier machines or electric motors and industrial machinery. A distance of
20 feet is advisable for minimum interference.
■ The base should be located at least 3 feet from metal sources. These
include metal reinforced ceilings, metal window frames, concrete reinforced
with metal, sheet metal walls, steel 1-beams, metal studs in walls, screens,
and fences.
■ Some solid structures, such as moist concrete walls, brick walls, and steel
reinforced concrete walls, will inhibit the range.
■ If more than one cordless phone is being used, do not place a handset
from one cordless phone into the base of another. If this accidentally
occurs, place each handset in the correct base for at least 10 seconds.
Switch Administration
Aliasing
For all System 75, System 85, DEFINITY Generic 1, and Generic 2 switches, and
DEFINITY Generic 3, Versions 1 and 2, the MDC 9000 terminal must be
administered as a 7303S Hybrid terminal.
Beginning with the DEFINITY Generic 3, Version 3 (or later), the MDC 9000 can
be administered as itself.
For the System 85, R2V1 through R2V4 switch which does not accommodate
Universal modules, an ANN17B Hybrid pack in conjunction with a DS-1 carrier
must be used to connect the switch and the MDC 9000 terminal. On all other
switches, including System 75, DEFINITY Generic 1, Generic 2, and Generic 3,
and the DEFINITY ECS, a TN62B Hybrid pack must be used with the Universal
carrier for this purpose.
NOTE:
A DEFINITY Generic 2 may use either an ANN17B or a TN62B pack. In
either case, the latest vintage packs are recommended.
Button Numbering
Only the system manager should administer feature button assignments on the
telephone. It is recommended that you not use a feature that requires visuals (that
is, the light next to each administrable button) to be updated while the set is turned
off, or any feature that may be activated by button depression while the set is
turned off (for example, Send All Calls).
Use Figure 18-3 for button numbering on the MDC 9000 set when it is connected
to a System 75, a DEFINITY Generic 1 or Generic 3, or to a DEFINITY ECS. Use