Filter
Top Products
CDM-Qx Satellite Modem Revision 4
Remote Control MN/CDMQx.IOM
C-11
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
query
(Target to
Controller)
TX Spectrum
Invert
TSI= 1 byte, value of
0, 1
Command or Query
TX Spectrum Invert Selection, where:
0=Normal
1=TX Spectrum Invert
Example: TSI=0 (Normal)
TSI=
TSI?
TSI*
TSI#
TSI$
TSI^
TSI@
TSI? TSI=x
(see description of
arguments)
TX Scrambler TSC= 1 byte, value of
0, 1, 2
Command or Query
Tx Scrambler state: where:
0=Off
1=ON (Default scrambler type)
2=ON IESS-315 (Turbo Only)
Example: TSC=1 (Scrambler one)
TSC=
TSC?
TSC*
TSC#
TSC$
TSC^
TSC@
TSC? TSC=x
(see description of
arguments)
TX Carrier
State
TXO= 1 byte, value 0
though 4
Command or Query
TX Carrier State, where:
0=OFF due to front panel or remote control command
1=ON
2=RTI (Receive/Transmit inhibit)
3=OFF due to EXT H/W TX Carrier Off command (not a
valid argument when used as a command)
4=OFF due to BUC warm up delay (not a valid argument
in a command format)
Example: TXO=1 (TX Carrier ON)
TXO=
TXO?
TXO*
TXO#
TXO$
TXO^
TXO@
TXO? TXO=x
(see description of
arguments)
TX Power Level TPL= 4 bytes Command or Query
TX Output power level between -5 and –25 dBm (minus
sign assumed)
Example: TPL=13.4
(Command not valid in AUPC mode)
Note: When output power level is enabled: Power level
configuration is not allowed. Response will be TPL*. The
response to the query TPL? Will be the adjusted levelled
value.
TPL=
TPL?
TPL*
TPL#
TPL$
TPL^
TPL@
TPL? TPL=xx.x
(see description of
arguments)