Filter
Top Products
CDM-Qx Satellite Modem Revision 4
Remote Control MN/CDMQx.IOM
C-22
Parameter
Type
Command
(Instruction
Code and
qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
query
(Target to
Controller)
T1 Line
Build-Out
LBO= 1 byte, value
of 0 though 4
Command or Query.
Valid only for T1 interface, where:
0=0 to 133 feet
1=133 to 266 feet
2=266 to 399 feet
3=399 to 533 feet
4=533 to 655 feet
Example: LBO=2
LBO=
LBO?
LBO*
LBO#
LBO$
LBO^
LBO@
LBO? LBO=x
(see description
arguments)
IP Address IPA= 18 bytes
numerical
Command or Query
Used to set the IP Address and network prefix for the
10/100 BadeTX Ethernet management port, in the format:
xxx.xxx.xxx.xxx.yy where:
yy is the network prefix (0 to 31)
Example: 010.006.030.001.24
IPA=
IPA?
IPA*
IPA#
IPA? IPA=xxx.xxx.xxx.x
xx.yy
(see description of
arguments)
Request to
Send
RTS= 1 byte, value
of 0, 1, 2
Command or Query
Defines how RTS/CTS will operate at the main data
interface
0=RTS/CTS Loop, No Action
RTS and CTS are looped, so that CTS echoes the state
of RTS, but RTS does not control the ON/OFF state of
carrier.
1=Loop, RTS Controls TX O/P
RTS and CTS are looped, so that CTS echoes the state
of RTS and RTS controls the ON/OFF state of carrier (in
order words, the modem will not bring up its TX carrier
until RTS is asserted.
2=Ignore RTS, Assert CTS
Example: RTS=0 (RTS/CTS Loop, No Action)
RTS=
RTS?
RTS*
RTS#
RTS^
RTS? RTS=x
(see description of
arguments)