Filter
Top Products
CDM-Qx Satellite Modem Revision 5
Front Panel Operation MN/CDMQx.IOM
5–37
Edit the address of the distant-end modem that this unit will pass messages to. This is
accomplished by selecting the digit to be edited, using the ◄ ► arrow keys. The value of
the digit is then changed using the STarrow keys. The user should then press ENT.
There is a restriction on values that can be entered here - they may only be in increments
of 10. This is automatically taken care of - the user may not edit the last digit of the
address. This has been implemented so that a single MASTER may pass messages for up
to 10 devices at the distant end. The valid range of addresses is from 10 to 9990.
But if SLAVE is selected, then the following sub-menu is displayed:
Edit the address of this SLAVE unit. This is accomplished by selecting the digit to be
edited, using the WXarrow keys. The value of the digit is then changed using the
STarrow keys. The user should then press ENT. The valid range of addresses is from 1
to 9999, although ‘base 10' values will be automatically skipped.
Remember that this is a unit that is intended to be located at the distant-end of
a link, and will therefore be under the control of a MASTER at the other
end. This is the equivalent of putting the unit into Remote Control mode -
no local control is possible.
(ConfigFrameD&I++) – D&I++
If D&I++ is selected, the following sub-menu will be displayed:
Drop & Insert: EDMAC
Drp-CH/TS Ins-CH/TS (◄ ►, ENT)
If Drp-CH/TS is selected, the Tx Data Rata will be displayed.
If the Ins-CH/TS is selected the Rx data rate will be displayed.
Address of this Slave
Unit: 0241 (◄ ►,▲ ▼,ENT)
Distant-end Base Address
0240 (◄ ►,▲ ▼, ENT)
IMPORTANT